There they be!

“They’re porpoising,” I thought to myself. “Jesus, they are everywhere!”

I decided to cast my rope fly right in between two of the shapes that had just risen out of the water and dove back into to darkness of the deep cove. Slowly I stripped in the fly; strip, pause, strip, pause, strip, strip, strip, pause… then all Hell broke loose!

“Holy Shit,” I thought to myself, “That is a dinosaur! Do Not Fuck This Up, Slow And Steady, Do Not Give It Any Chance To Throw The Fly!”

Keeping the slack out of my fly line, turning the my rod against the way the fish was trying to go, keeping the line tight as the fish went aerial, slowly and steadily stripping in line I came to face to face with a prehistoric nightmare fish, a true monster with the teeth to prove it – I had finally caught a Gar! Sorry that I am not talking about a musky, I wish I was, but it was most definitely a Gar and it was the biggest fish I have caught to date – a whopping 39 inches (one inch away from a citation trophy fish).

Gar fishing for the most part is frown upon in both the spinning and fly fishing communities, Realistically the only fishermen that fish for Gar on a constant basis are bow fishermen. I think the main stigma of fishing for gar by both spin and fly fishermen comes from the fact that hooking a gar is damn near impossible, their beaks are almost complete bone and the only way to actually hook them is to let them run for 20 or so yards and swallow the lure/fly, then you can hook them.

The only other way to fish for gar is to use a rope fly, it is a simple thing really; to make one use a 2 to 10 inch nylon rope that has been unbraided and combed out, doubled the rope in a small key chain ring, and secured using several wraps of gsp , then coat the wraps with head cement.  Basically what these flies do is Velcro the mouth of a gar shut, entangling them so there is little chance of them getting away (however if you don’t let them run first and automatically try to “set the hook”, you will pull the rope flies clean out of their beaks).

Honestly I think the next part is what really makes spin and fly fishermen not want to catch these fish. Once you get the gar in the net and next to boat, you have to get the rope fly untangled and out of it’s mouth. Sounds easy enough… um no it is not. Gar have hundreds of razor sharp teeth, their scales are like razors, and they just don’t sit there all nice as you try to get the fly out of their mouth, to be honest you can see how pissed off they are just by looking into their black eyes… they want to bite the shit out of you. Everything about a gar makes them very unfriendly to spin and fly fishermen.

So how the hell do you get a rope fly out of a gar’s mouth? Well you have to be very careful and patient. First thing you need to do before going gar fishing is to go your local hardware store and buy a crowbar, a pair of very longnose pliers, and some stout leather gloves. Granted you only need one of the gloves, the one that you will be holding the fish with, but you definitely need them, believe me I know! I didn’t use a pair of gloves one time and my hand felt like it had paper cuts all over the palm and fingers of my hand. Trust me; use gloves!

Once you net a gar leaving them in the net like you would a musky, take the crowbar and pry open its mouth (aim for the back part of the mouth  where the teeth are the smallest. After you get the crowbar in its mouth and pry it open it is time to try and get the rope untangled. You can use the pliers to try and pull the tangles out, however I have found that if you just use your glove free hand you can get the rope fly out faster, but once again remember these fish are out to bite the shit out of you, you have just became their nemesis. Once they are free of the rope fly, put on the other glove, pick the gar out of the net, get a quick picture, then release them quickly. Always measure them in the water before picking them up, if they are close to citation try and go to a dock or land to get the photo of the gar’s measurement. Once again, take my word, there is nothing scarier than a gar flopping in your boat, teeth just chopping away and you trying to get the damn thing out of your boat or back on to the bump board for a measurement.

So why should an angler fish for gar? Well it is like musky fishing; realistically you are not fishing, instead you are hunting a fish. You have to spot them, cast with precision, and try not to spook them all at the same time. Not to mention watching a gar follow your fly up to your boat might be one of the coolest things ever to watch. I thought initially that these fish were spooked by boats, nope I was wrong. Not to mention there is something primal about catching a fish that is so prehistoric, to see it close and personal, they are truly a wonder of the world. Plus here in the lower Eastern United States what else are you going to fish for that is so close to a musky? 

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Google photo

You are commenting using your Google account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s